Parts Washer Solvent

PARTS WASHER SOLVENT

DESCRIPTION

This is a high quality, high flash point, low odor petroleum solvent.  Use it in soak tanks or recirculating solvent parts washers. It rapidly and safely removes even stubborn, baked on grease from all metals, and most rubber and plastics.  It won’t cause rust or corrosion.

It is recommended for use in Automotive Repair Shops, Car and Truck Dealers, Heavy Equipment Dealers, Marine Repair Yards, Oil Wells, Industrial Maintenance, Public Works Departments, Railroad Maintenance, Building Maintenance, and anywhere that grease and oil are a problem.

Oil reclaimers can use the spent solvent in fuel oil if it is not contaminated with carburetor cleaners, flammable solvents, etc.  

DIRECTIONS

It is ready to use in soak tanks and re-circulating solvent parts washers.  Apply by spray, brush, rag, or dipping. Allow to soak, or scrub with a brush.  Wipe dry with a towel or let it air dry.

CAUTION

Wear protective gloves and eye protection when using solvents.

Eye contact causes irritation.  Immediately remove contact lenses and flush eyes with plenty of water, lifting eyelids to insure thorough flushing.

Skin contact may cause irritation.  Repeated or prolonged skin contact may de-fat the skin.  Wash with soap and water.

Inhalation of excessive amounts of vapors or spray mists may cause respiratory irritation.  Remove to fresh air.

Ingestion may be harmful.  Aspiration hazard if swallowed.

WARRANTY

Mobile Solvent & Supply, Inc. products are safe and effective when used as directed.  When using as a cleaner, always test a small area for adverse reaction. Since the manufacturer cannot control conditions or method of application, no warranty or liability beyond the replacement of defective product is offered.

KEEP OUT OF REACH OF CHILDREN

Brake and Parts Cleaner

BRAKE & PARTS CLEANER

•NO CHLORINATED OR FLUORINATED SOLVENTS•

  • REMOVES BRAKE FLUID, GREASE, AND OIL•
  • CONTAINS NO LEAD, PHOSPHORUS, OR SILICONE•

DESCRIPTION

This highly concentrated solvent blend provides maximum performance in a brake parts cleaner without the use of ozone depleters or chlorinated solvents.  It easily removes brake fluid, grease, oily dirt and contaminants from linings, pads, drums, cylinders and springs without disassembling the brake unit.

DIRECTIONS

Spray brake parts liberally and allow to run off.  Allow to air dry. Repeat as necessary. Protect rubber and plastic parts from spray.  Do not spray on hot surfaces.

CAUTION

Flammable mixture.  Flammable vapors are heavier than air and may collect in low areas or pits.  Vapors may travel long distances from point of use and be ignited by sparks, smoking, flames, heaters, electrical equipment, static discharge, or other ignition sources.  Provide adequate ventilation during use. Waste oil contaminated with this product poses a flammability hazard.

Contains petroleum distillates.  Skin contact may produce skin irritation.  Wash with soap and water. Eye contact may produce severe irritation. Flush thoroughly with plenty of water for at least fifteen minutes, lifting eyelids periodically.   Inhalation of mist or vapor may produce respiratory tract irritation. Move victim to fresh air. If breathing does not return to normal after a few minutes, get medical attention.  If swallowed, DO NOT INDUCE VOMITING, call a physician immediately.

WARRANTY

Mobile Solvent & Supply, Inc. products are safe and effective when used as directed.  When using as a cleaner, always test a small area for adverse reaction. Since the manufacturer cannot control conditions or method of application, no warranty or liability beyond replacement of defective product is offered.

KEEP OUT OF REACH OF CHILDREN