This is a heavy duty cleaning and brightening agent designed to remove oxidation, diesel smoke, oil, and dirt from aluminum surfaces.  It lightly etches the aluminum surface and floats soils away leaving a fresh, clean surface. It contains acids, penetrants, detergents, and emulsifiers in combination designed to provide efficiency and economy in cleaning aluminum.


Aluminum brightener should be diluted with water.  Solution concentration will depend upon the job and equipment available, although the usual ratio is 1 part cleaner to 9 parts water.  It may be applied by spray or brush. The surface to be cleaned should first be wet with water and aluminum brightener applied from the bottom up to prevent streaking.  Agitate the surface with a brush if necessary and allow the cleaner to remain on the surface for approximately ten minutes; do not allow to dry. If allowed to dry on the vehicle, streaking may occur.  Flush thoroughly with water to remove cleaner and stop it’s action.


Contains sulfuric acid and hydrofluoric acid, UN 1786, corrosive and poison.  May cause burns to eyes and skin. May be harmful if swallowed. In case of eye contact, flush with plenty of water for at least 15 minutes, and get medical aid.  In case of skin contact, flush with water and get medical aid if needed. If swallowed, DO NOT INDUCE VOMITING, drink large amounts of water and get medical aid immediately.


Mobile Solvent & Supply, Inc. products are safe and effective when used as directed.  When using as a cleaner, always test a small area for adverse reaction. Since the manufacturer cannot control conditions or method of application, no warranty or liability beyond replacement of defective product is offered.


About Joe White